JVC HR-VP78U
Instrukcja Obsługi

EN

25

Basic Recording
Turn on the VCR and the TV, and select the VCR channel 3 or 4 (or AV mode) on the TV. SHUTTLE ring POWER PLAY ( # )
4

2

On the front panel: Press CH 5�.

Select recording channel

On the Remote: a� Press CH + or �. or b� Press the Number keys. � If you connect the TV and the VCR only using the RF connection, press TV/VCR on the Remote so that the VCR mode indicator lights on the front display panel, to view the program to be recorded.

Set tape speed
3
REW PLAY FF

Press SP/EP to set the recording speed.

POWER

Start recording
MENU
VIDEO (MONO)L�AUDIO�R
SP EP VCR

4
CH
SP/EP
REC STOP/EJECT PAUSE

OK

On the front panel: Press REC ( ¶ ). On the Remote: While holding REC ( ¶ ), press PLAY ( 3 ). � If �VIDEO CALIBRATION� is set to �ON� (default setting: pg. 38, 39), this VCR checks the tape condition for about seven seconds, then starts recording. This means that the first seven seconds of the program will not be recorded. If this is inconvenient for you, follow the steps below: Press REC ( ¶ ) and PAUSE ( 8 ) to start Video Calibration. Then press PLAY ( 3 ) to start recording after Video Calibration is complete.

23

STOP/EJECT (7/0) PAUSE ( 8 ) POWER TV/VCR
1 4 7 2 5 8 0 3 6 9
4 2
2

�b

1 2

To pause recording
Press PAUSE ( 8 ). To resume recording, press PLAY ( 3 ).
2

�a

To stop recording
Press STOP ( 7 ) on the Remote or STOP/EJECT ( 7 / 0 ) on the front panel.

1
3

REW ( 1 )

FF ( ¡ ) PAUSE ( 8 )
3

To rewind the tape (when the tape is not running)
Press REW ( 1 ) (or turn the SHUTTLE ring on the front panel to the left).

To fast-forward the tape (when the tape is not running)
Press FF ( ¡ ) (or turn the SHUTTLE ring on the front panel to the right).

4

To eject the tape
STOP ( 7 ) This VCR can check the tape condition during recording (and playback), and realizes the best possible pictures. Press STOP/EJECT ( 7 / 0 ) on the front panel when the tape is not running. � You can also eject the cassette with the VCR turned off.

To turn off the VCR
Press POWER.

Load a cassette
1

Make sure the record safety tab is intact. If not, cover the hole with adhesive tape before inserting the cassette.