JVC HR-XV38SAG
Instrukcja Obsługi

24 EN Recording Features
� Turn on the TV and select the video channel (or AV mode). � Slide the TV/VCR/DVD switch on the remote control to the right.

OPERATIONS ON VHS DECK (cont.)

3 Set the recording duration.

If you want to record for more than 30 minutes, press 7 to extend the time. Each press extends recording time by 30 minutes.

NOTES:

� You can only perform ITR using the 7 button on the unit�s front panel. � When the end of the tape is reached during Instant Timer Recording, the unit is turned off and � � and �$� blink on the front display panel. � When the end of the tape is reached during timer recording, the unit is turned off and �7�, �4� and �#� blink on the front display panel.

Slide to the right.

Elapsed Recording Time Indication
1 Set the counter display.
Press � �:� � until a counter reading appears on the front display panel.

2 Reset the counter.
Press 0000 before starting recording or playback.
� The counter is reset to �0:00:00� and shows the exact elapsed time as the tape runs. You can check the exact time of a recording or playback.

Tape Remaining Time Record One Programme While Watching Another
Once recording is in progress, all you need to do is to set the channel controls on the TV for the station you wish to view.
� The programme selected with the TV�s channel controls appears on the TV screen, while the one selected with the unit�s PR buttons is recorded on the tape. � By pressing the � �:� � button, you can change the display to show the channel position, clock time, counter reading, and tape remaining time.
* The channel position is not displayed during playback.

Press � �:� � until the time remaining on the tape appears.

� The front display panel shows the tape remaining time with �:� displayed.

NOTE:
You can also use the DVD deck in the following cases. Before use, be sure to turn on the unit and select the DVD deck. � During recording � During timer recording � During timer standby mode

NOTES:

Instant Timer Recording (ITR)
This easy method lets you record for from 30 minutes to 6 hours (selectable in 30-min. increments), and shuts the unit off after recording is finished.

� When you press � �:� �, the on-screen display appears on the TV screen for 5 seconds. � Depending on the type of tape being used, the tape remaining time reading may not appear right away, or is not correct. �� �:� �� may sometimes appear with �:� blinking, or the display may blink on occasion.

1 Start recording.
Press 7 on the unit.

2 Engage the ITR mode.
Press 7 again. � � blinks and �0:30� appears on the front display panel.