jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 27 (kliknij aby zobaczyć)
If the upgrade is cancelled or any error is occurred during the loading process, a warning message is displayed and user is asked to press the SELECT button for returning the last watched channel.
After loading the software into memory (SDRAM), it will be written permanent memory (flash).If the STB power is down while new software is being written into the flash memory then new software will not run and old software will be cleaned also. The restoring code is G-O-L-F (3-5-4-2).To restore the receiver software please power off the stb from mains. When you power on the stb again you will recognize that the led at the front panel is first green for some time and then it is turning into red colour. To open the zipped software
which is stored in the factory you should at least press the G button of the remote control
