Getting Started (continued)
Setting up Progressive Scan feature (for Progressive Scan TV only) The progressive scan display twice the number of frames per seconds than interlaced scanning (ordinary normal TV system). With nearly double the number of lines, progressive scan offers higher picture resolution and quality. IMPORTANT! Before enabling the progressive scan feature, you must ensure : 1) Your TV can accept progressive signals, a progressive scan TV is required. 2) You have connected the DVD system to your TV using Y Pb Pr (see page 11).
7 Press 1 to highlight
OK
in the menu
E n g l i s h
and press OK to confirm. There will be no picture on your TV at this state until you turn on the progressive scan mode on your TV. Turn on your TV progressive scan mode (refer to your TV user manual). � The below menu will appear on the TV.
Confirm again to use progressive scan If picture is good press OK on remote
8
OK
Cancel
9 Press 1 to highlight
1 Turn off your TV progressive scan mode
or turn on interlaced mode (refer to your TV user manual).
in the menu and press OK to confirm. � The set up is complete now and you can start enjoy the high quality picture.
OK
If no picture: G Wait for 15 seconds for auto recovery.
2 Press DISC on the remote to turn on
the DVD system.
1 2
OR Deactivate Progressive Scan feature by pressing the OPEN CLOSE 0 on the DVD system to open the disc tray. Press 1 on the remote control. � The blue DVD background screen will appear on the TV. Helpful Hint: � There are some progressive scan TV and High-Definition TV sets that are not fully compatible with this DVD system, resulting in the unnatural picture when playing back a DVD VIDEO disc in the progressive scan mode. In such a case, turn off the progressive scan feature on both the DVD system and your TV set.
3 Turn on your TV and select the correct
Video Input channel (see page 17). � The blue DVD background screen will appear on the TV.
4 Press SETUP on the remote. 5 Press 2 to select { Video Setup Page }.
Video Setup Page TV Type TV Display Progressive Picture Setting On Off
3 Press MUTE on the remote.
6 Select { Progressive } > { On }, then
press OK to confirm. � The below menu will appear on the TV.
HINTS:(refer to the owner's manual) ACTIVATING PROGRESSIVE: 1. Ensure your TV has progressive scan. 2. Connect with YPbPr(GBR) video cable. 3. If there is a blank screen on normal TV, wait 15 seconds for auto recover.
OK Cancel
TIPS:
The underlined option is the factory default setting. To return to the previous menu, press 1. To remove the menu, press SETUP.
