Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 46 (kliknij aby zobaczyć)
HT-X1W
Listening to the radio (continued)
! Memorising a station
You can store 40 AM and FM stations in memory and recall them at the push of a button. (Preset tuning)
ENGLISH
! To recall a memorised station
Press the TUNER PRESET ( or onds to select the desired station. ) button for less than 0.5 sec-
Radio
1 2
Perform steps 1 - 3 in "Tuning" on page 44. Press the ENTER button to enter the preset tuning saving mode.
To select a preset station with the direct number buttons: 1 Press the corresponding number ("0" - "9"). 2 Press the ENTER button. Example: To select 28, press "2", "8" and "ENTER".
! To scan the preset stations
3
Within 5 seconds, press the TUNER PRESET ( ton to select the preset channel number.
or
) but-
Store the stations in memory, in order, starting with preset channel 1.
The stations saved in memory can be scanned automatically. (Preset memory scan) 1 Press the TUNER PRESET ( or ) button for more than 0.5 seconds. The preset number will flash and the programmed stations will be tuned in sequentially, for 5 seconds each. 2 Press the TUNER PRESET ( or ) button again when the desired station is located.
4
Within 5 seconds, press the ENTER button to store that station in memory.
If the "PROGRAM" and preset number indicators go out before the station is memorised, repeat the operation from step 2.
! To erase entire preset memory
1 2 Hold the CLEAR button down for 4 seconds or more. Within 10 seconds, press the ENTER button.
5
Repeat steps 1 - 4 to set other stations, or to change a preset station. When a new station is stored in memory, the station previously memorised will be erased.
Note: The backup function protects the memorised stations for a few hours should there be a power failure or the AC power lead get disconnected.
