|
Kto jest w sklepie?
Sklep przegląda 5879 gości
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
INTERMEZZO 4.1t
Service Bulletin
Service Bulletin INF2003-03 - June 2003 To: All Infinity Service Centers Warranty labor rate: MAJOR repair
Model: Intermezzo 4.1t Subject: Distortion at Low Volume Levels In the event you receive an Intermezzo 4.1t with the complaint �there is distortion at low volume levels, particularly when higher frequencies are present�, perform the following procedure: Synopsis: Remove three components and re-wire them in a similar circuit on the opposite side of the Feature PCB. 1) Remove the woofer grille; extract the (6) rubber grille retainers; this can be accomplished by carefully pulling them out of their cavities with long-nosed pliers or similar tool. 2) Remove the (6) Phillips screws from the woofer trim ring. 3) Remove the trim ring with the woofer attached; unplug the two wire leads. 4) Remove the (6) Phillips screws at the rear of the enclosure, and push the amplifier assembly into the enclosure. 5) Unplug the three connectors from the amplifier; remove the amplifier from the woofer opening. 6) Remove the 4 screws holding the front faceplate w/ controls and Feature PCB to the plastic enclosure; pull the assembly out as far as the attached wires will allow. If the rectangular gasket bordering the enclosure is damaged during this procedure, order Infinity part# MM0080. 7) Unplug all wire connectors on the PCB except the AC power wires, which can remain attached. 8) Remove the 2 screws holding the HP push button switch assembly to the faceplate; remove the assembly and plastic spacers. 9) Locate and remove resistors R153 (2.2K�), R154 (5.6M�) and diode D110 (1N4148). 10) Resolder the three components together on the rear of the PCB, following the examples below: �Circuit Equivalent�, and supplied image on Page 2. Observe polarity for D110. Solder an insulated 16 - 20 gauge (0.5 to 1.0 mm2) jumper wire to the cluster of parts to complete the connection. Cut the PCB traces in the indicated areas. Add a dab of silicon sealer or equivalent adhesive to hold the components in place on the PCB.
18
|
|
|
> |
|