Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
Interior
Shelves
Fresh Food Compartment Elevator
TM
Designs
and Door HE$
Shelf
The fresh food compartment is equipped with 3 Elevator'" shelves. These shelves have a spill retainer edge for easy clean up. They also have the convenient slide out feature that allows easy access to items stored at the rear of the shelf. These shelves can be adjusted up or down without having to be unloaded of their contents. To adjust an Elevator '_' shelf, unfold the recessed crank handle so it is at a right angle to the shelf front. Crank to the right (clockwise) to raise the height of the shelf, and the left (counterclockwise) to lower the height of the shelf. To remove the Elevator '_'shelf for occasional cleaning: � Completely unload the shelf. � Grasp the shelf front and pull forward until it stops. � Press the stops from below (both sides) upward and continue pulling the shelf forward, clear of the frame. � To reinstall, align the shelf to the frame and push it all the way back. (There is no need to depress the stops for reinstallation). In ordinary use, the Elevator r"shelf with the frame assembly does NOT require removal. Though unlikely, and not recommended, the correct removal procedure is as follows: � Unload the shelf completely. � Slide the shelf forward about two inches and manually move the two rear latches toward the shelf center. � While supporting the entire shelf and frame from underneath, lift slightly and rotate the assembly approximately 30° to allow the rear mechanism to clear the vertical rear side rails. � The entire assembly can then be moved forward and clear of the refrigerator compartment. � To reinstall, reverse the removal procedure. Be sure the shelf is in a level position. When the sliding shelf is pushed to the rear, it will reposition the rear latches to their correct operating position.
