INHALT
Warnungen und wichtige Hinweise Hinweise zur Verpackungsentsorgung Gebrauch Bedienungsblende Reinigung der Innenteile Inbetriebnahme Temperaturregelung Klimadruckknopf Hinweise zum richtigen KŸhlen Einfrieren von frischen Lebensmitteln Aufbewahrung der TiefkŸhlkost EiswŸrfelbereitung Auftauen Hšhenverstellbare Abstellregale Hšhenverstellung der TŸrablage 2 3 5 5 5 5 5 5 5 5 6 6 6 6 6 7 7 7 7 7 8 8 8 8 9 9 9 10 10 11
Interior light
The light bulb inside the refrigerator compartment can be reached as follows: - unscrew the light cover securing screw. - unhook the moving part as shown in the figure. If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. The rating is shown on the light bulb cover.
D613
Defrosting
Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: 1. pull out the plug from the wall socket or turn the thermostat knob to the �O� setting; 2. remove any stored food, wrap it in several layers of newspaper and put it in a cool place; 3. leave the door open, and insert the plastic scraper in the appropriate seating at the bottom centre, placing a basin underneath to collect the defrost water. 4. when defrosting is completed, dry the interior thoroughly; keep the scraper for future use; 5. turn the thermostat knob back to the required setting or replace the plug in the power socket. 6. After two or three hours, reload the previously removed food into the compartment. Important: Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a maechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life.
