Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 11 (kliknij aby zobaczyć)
ca. 50 mm
90°
8mm
21 mm
90°
K Ha
ca. 50 mm
21
mm
PR167
6. Place guide on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied.
9. Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K).
Ha
Hc
PR168 PR33
Hb 10. Place the small square on the guide again and fix it with the screws supplied. Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly.
7. Fix cover (Hc) on guide (Ha) until it clips into place.
8mm
Hb
Ha Hb
Hd
PR167/1
PR167
8. Open the appliance door and the furniture door at 90¡. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes as indicated in the figure.
11. Fix cover (Hd) on the small square (Hb) until it clips into place.
