BEFORE YOU BEGIN
NOT FOLLOWING THIS MANUAL WILL VOID YOUR WARRANTEE. FAILURE TO SEND IN THE WARRANTEE CARD WILL VOID YOUR WARRANTEE. � Be very careful when handling the tone arm. The internal arm wire is exposed at the headshell and at the rear of the arm. This wire is very delicate and contains 64 strands of very pure copper. Physical damage to the wire is not covered by the warranty after the arm is removed from its box. Please do not touch the unipivot bearing parts. Finger oils on the bearing cup in the upper bearing housing or on the lower pivot point in the arm base assembly can cause blemishing of the bearing and possible corrosion. Also, the point is sharp, be careful. There are a number of setscrews on the JMW Memorial Tone Arm. The Allen wrench that comes with your arm will only fit the setscrews that you will need to adjust. All other screws are factory set and should not be adjusted, except by our trained technicians. Resetting any of the factory settings is not covered by the warranty. DO NOT PUT THE DAMPING FLUID IN THE ARM UNTIL YOU ARE FINISHED WITH ALL THE ADJUSTMENTS
�
�
UNPACKING YOUR JMW MEMORIAL TONE ARM
� � This instruction manual was lying on a large foam pad. Remove the pad and put it nearby on your work surface. You will now see a number of things in plastic bags: � A bottle of arm damping fluid � Allen wrenches � Hex nuts, and washers (for cartridge mounting) � Arm mounting and alignment tool � �Q� tip � Shure stylus gauge Take all these items out and set them aside. Be careful with the damping fluid. It should be kept sealed until it is used. You will now see a thick foam pad hiding the things you really want to get at. Reach between the pad and any one side of the box, lift the pad out, and set it aside as well. You can now see the arm tube and counterweight, with its delicate 4-color wire and Lemo connector, and the arm base assembly. If your arm is pre-mounted on a tone