Bardzo dobra jakość skanu, przystępna cena. Instrukcja serwisowa okazała się przydatna przy "reanimowaniu" dwudziestoparoletniego decka, który teraz pięknie gra :)
Tekstowy podgląd strony 116 (kliknij aby zobaczyć)
4) Remove the charger cleaner from its slot under the power socket at the rear of the printer.
Wire
5) The main charger is located inside the slot at the base of the raised photoconductor cartridge. A flexible plastic flap is fitted along the inside of the slot. Insert the red brush into one extreme end of the slot. The lug above the brush on the charger cleaner fits into the groove above and parallel to the slot in the photoconductor cartridge. Draw the charger cleaner all the way along the main charger to the other end of the slot, either to the left or the right. Go the complete width, from one side of the cartridge to the other. Do not take the charger cleaner out halfway.
3) Put the charger cleaner back into its slot at the rear of the printer. 4) Close the front cover.
6) Put the charger cleaner back into its slot at the rear of the printer. 7) Pivot the photoconductor cartridge gently back into place. 8) Close the front cover.
(2) Cleaning the Transfer Charger Unit
1) Carry out steps one and two to open the front cover in the same way as for the main charger on the preceding page. Do not move the photoconductor cartridge. Leave it in place. 2) The transfer charger is on the open side of the front cover. The black indented edge of the charger cleaner fits over the wire and the other angled scraper surfaces fit against other parts of the printer as shown in the illustration. Look at the printer from the side and use the illustration as a guide when applying the charger cleaner to the transfer charger. The direction of movement is important. Looking at the open printer from the back, draw the charger cleaner from left to right along the wire. Going in the opposite direction may damage the wire. Make one complete sweep, from the left end of the wire to the right end. Do not stop halfway.
