jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 30 (kliknij aby zobaczyć)
B. ADJUSTMENT OF THE A/C HEAD ASS'Y (TILT ADJUSTMENT)
a. Play back a T-120 Tape and check the running condition of the TAPE at the lower flanges of the T GUIDE POST ASS'Y ¤æin Fig. 5-1. b. Adjust the A/C HEAD TILT SCREW untill the TAPE runs stable as shown in Fig. 5-2
TURN THE A/C HEAD TILT SCREW TO THE DIRECTION OF CW
(
)
(
)
TURN THE A/C HEAD TILT SCREW TO THE DIRECTION OF CCW
Fig. 5-2 A/C HEAD ASS'Y ADJUSTMENT (TILT ADJUSTMENT)
C. ADJUSTMENT OF THE AUDIO AZIMUTH (See Fig.5-3)
a. Play back the ALIGNMENT CASSETTE TAPE (NTSC: DN2 (SP 7KHz), PAL: DP2 (SP 6KHz)) , , b. Observe audio signals on an OSCILLOSCOPE. c. Turn the A/C HEAD AZIMUTH SCREW to obtain the maximum audio output signal (-9~-3dBm).
Fig. 5-3 A/C HEAD ASS'Y
D. THE HEIGHT ADJUSTMENT OF A/C HEAD
a. Play back a T-120 TAPE. b. Make sure that the gap is 0.25mm between the lower end of TAPE and that of A/C HEAD. c. When the gap is longer than 0.25mm, turn the A/C HEAD HEIGHT ADJUST NUT counter-clockwise. When the gap is shorter than 0.25mm, turn it clockwise. Repeat this procedure untill 0.25mm is obtained.
GAP
Fig. 5-4 A/C HEAD ASS'Y ADJUSTMENT (HEIGHT ADJUSTMENT)