s Power and Speakers cable connection
Subwoofer Power control cable Distribute the speaker cables and sigma servo cables along the same paths.
FUSE(20A)
POWER IN BATT
20
GND
� SERVO ��
P.CON(REMOTE)
SPEAKER OUTPUT
� SERVO ��
FUSE(20A)
20
Terminal cover
Power control (REMOTE) lead terminal Ground cable (Black)
Battery cable (Yellow)
� If a buzzing noise is heard from the speakers when the engine is running, connect a line noise filter (optional) to each of the battery cable. � Do not allow the cord to directly contact the edge of the iron plate by using Grommets. Fire wall Grommets Battery
+ -
Round terminal (Large)
2WARNING
NOTE
To prevent fire caused by a � Connect the ground cable to a metal part of the car chassis that short in the wiring, connect acts as an electrical ground passing electricity to the battery�s a fusible link or breaker negative - terminal. Do not turn the power on if the ground cable nearby the battery�s is not connected. positive terminal. � When installing two amplifiers, connect a power tune-up cable to each of them while taking care not to exceed the cable capacity. � The power cable should be thick enough to supply the required current and connected directly from the battery.
Speaker output cable terminal Connect the speaker output cables to these terminals.
Lead terminal (Commercially available part) Speaker output cable
Power terminal Pass battery and ground cables through supplied terminal cover and connect to respective terminals. After completing connections, fasten terminal cover over terminal bracket. Round terminal (Medium) Round terminal (Small)
