INFINITY KAPPA693.1I
Instrukcja Obsługi

A NOTE ON POWER HANDLING
Kappa speakers are designed to produce reasonable volume levels with little amplifier power. However, the addition of an amplifier to drive your speakers and a subwoofer will enhance the dynamic range of your system, and help overcome the ambient noise in a moving vehicle. Kappa speakers are designed to handle the power of a dedicated amplifier driven at or below its rated power. If an amplifier is driven far above its rated power, the output signal will �clip, and the � additional power present in a clipped signal can damage any speaker. Distorted or �fuzzy� sound from your speakers is an indication that the amplifier has exceeded its rated power, and you should reduce the volume level.

GENERAL CARE
The loudspeaker grilles may be cleaned with a slightly damp cloth. Do not use any cleaners or solvents on the grilles or the speaker cones.

SPECIFICATIONS: KAPPA STANDARD SERIES
42.1i Type: Speaker Impedance: Power Handling: Frequency Response: Sensitivity: Mounting Depth, Drop-in: Cut-out Diameter: 52.1i Type: Speaker Impedance: Power Handling: Frequency Response: Sensitivity: Mounting Depth, Drop-in: Cut-out Diameter: 62.1i Type: Speaker Impedance: Power Handling: Frequency Response: Sensitivity: Mounting Depth, Drop-in: Cut-out Diameter: 63.1i Type: Speaker Impedance: Power Handling: Frequency Response: Sensitivity: Mounting Depth, Drop-in: Cut-out Diameter: 4" 2-Way 4 ohms 45W 80Hz ~ 20kHz 89Hz @ 2.83 V, 1 watt 1-3/4" (45 mm) 3-3/4" (96 mm) 652.1i Type: Speaker Impedance: Power Handling: Frequency Response: Sensitivity: Mounting Depth, Drop-in: Cut-out Diameter: 692.1i Type: Speaker Impedance: Power Handling: Frequency Response: Sensitivity: Mounting Depth, Drop-in: Cut-out Diameter: 165 mm 2-Way 4 ohms 70W 50Hz ~ 20kHz 89Hz @ 2.83 V, 1 watt 2-9/16" (66 mm) 5-11/16" (145 mm)

5-1/4" 2-Way 4 ohms 50W 59Hz ~ 20kHz 89Hz @ 2.83 V, 1 watt 2-7/16" (62 mm) 4-13/16" (123 mm)

6" x 9" 2-Way 4 ohms 100W 38Hz ~ 20kHz 89Hz @ 2.83 V, 1 watt 2-3/4" (70 mm) 5-11/16" x 8-3/4" (145 mm x 223 mm)

6-1/2" 2-Way 4 ohms 70W 50Hz ~ 20kHz 89Hz @ 2.83 V, 1 watt 2-7/16" (62 mm) 5-1/8" (131 mm)

693.1i Type: Speaker Impedance: Power Handling: Frequency Response: Sensitivity: Mounting Depth, Drop-in: Cut-out Diameter:

6" x 9" 3-Way 4 ohms 100W 38Hz ~ 21kHz 89Hz @ 2.83 V 2-3/4" (70 mm) 5-11/16" x 8-3/4" (145 mm x 223 mm)

6-1/2" 3-Way 4 ohms 70W 50Hz ~ 21kHz 89Hz @ 2.83 V, 1 watt 2-7/16" (62 mm) 5-1/8" (131 mm)

-3-