Loosen the T-bolts for the stand and mount the legs on the stand. Install the legs as shown in the figure so that the ends of the legs protrude by about 2 cm.
Extend the leg by about 2 cm.
Mount the legs on the stand.
T-bolt
6. 7. 8. 9.
Tighten the T-bolts to secure the legs to the stand. Lift the KD-120 and place the stand and the four legs upright. Adjust the angle of the head surface so that it�s at a right angle to the floor. Use the included drum key to loosen the bracket bolts you tightened in step 3, and adjust the angle of the KD-120 pad so that the head surface is at a right angle to the floor. Install the included beater on your kick pedal. * Using a beater made of felt may result in wear to the felt. Use the special included beater or a plastic beater as the beater for the kick pedal. Mount the kick pedal on the KD-120. * Make sure there is about 1 cm of space between the two to keep the kick pedal�s chain (or belt) from touching the hoop of the KD-120 pad during play. Also, if the kick pedal has no under-plate, then arrange the stand�s plate section at a right angle to the floor.
Space apart by about 1 cm.
10.
f
90�
If the kick pedal has no under-plate, then arrange the stand�s plate section at a right angle to the floor.
11.
Make any fine adjustments necessary and tighten the stand brackets to make sure the KD120 is secure on the stand. Make sure the KD-120�s four legs and heel portion of the kick pedal is securely on the floor by loosening the stand�s T-bolts and adjusting the length of the legs. Adjust the striking point for the beater. Normally the beater�s striking point is adjusted to fall at the center of the head. Adjust the striking point so that it doesn�t extend beyond the cushion on the back of the head. Moving the striking point closer to the sensor increases the sensitivity, so carry out fine adjustment to suit your preferences.
