Removing the Unit
Removing the hard rubber frame 1 Engage the catch pins on the removal tool and
remove the two locks on the upper level. Upper the frame and pull it forward as shown in the figure.
Removing the Unit 1 Refer to the section 'Removing the hard rubber 2 3
frame' (page 27) and then remove the hard rubber frame. Remove the screw (M4 � 8) on the back panel. Insert the two removal tools deeply into the slots on each side, as shown.
Screw (M4X8) (commercially available)
Lock Catch
Accessory� Removal tool
2 When the upper level is removed, remove the
lower two locations.
Accessory� Removal tool
4 Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards the inside.
� The frame can be removed from the bottom side in the same manner.
� Be careful to avoid injury from the catch pins on the removal tool.
5 Pull the unit all the way out with your hands,
being careful not to drop it.
