Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 14 (kliknij aby zobaczyć)
ENGLISH
2
Tune in to a station (in this example, of 92.5 MHz).
To tune in to stations of higher frequencies
Tuning in to a preset station
You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see �Storing stations in memory� on pages 13 and 14.
To tune in to stations of lower frequencies
Selecting a preset station directly
1
Select the band (FM1 � 3, AM).
SRC
1 Press SRC (source) repeatedly to select the tuner. 2 Press and hold SRC. Each time you press and hold the button, the band changes.
3
Press and hold the number button (in this example, 1) for more than 2 seconds.
1
FM1
FM2
FM3
AM
2
Select the number (1 � 6) for the preset station you want.
1 2 3 4 5 6
The display pattern automatically changes like the above pattern (see page 15). The preset number flashes for about 5 seconds, then the previous display pattern resumes.
Note: You can also use the 5 (up) or � (down) button on the unit to select the next or previous preset stations. Each time you press the 5 (up) or � (down) button, the next or previous preset station is tuned in.
4
Repeat the above procedure to store other stations into other preset numbers.
When using the remote controller 1 Press FM or AM. FM
� When selecting the FM bands, press FM repeatedly until the band you want is selected.
DAB
Notes:
� A previously preset station is erased when a new station is stored in the same preset number. � Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.
AM
2 Press the number buttons (1 to 6) while
holding SHIFT (S).
SHIFT
TOP MENU
1
DISC +
MENU
2 3
S
ENTER
4 5 6
Note: You can also use the PRESET (FOLDER) 5 / � buttons for selecting a preset station.