Instrukcja Serwisowa jest kompletna i czytelna. Dziękuję!
Tekstowy podgląd strony 100 (kliknij aby zobaczyć)
KDL-26S3000/32S3000/40S3000/46S3000
2-5. VERIFYING SERVICE DATA CHANGES
1. After completing all adjustments turn the set off with the Remote Commander and then proceed to the next step. 2. Press the following buttons on the Remote Commander within a second of each other: DISPLAY Channel 5 Volume + POWER . 3. To verify the changes repeat steps 1 through 3 of 2-4. Using the Remote Commander to View Service Data. 4. To exit service mode, turn the power off by pressing POWER .
2-6. RESETTING TO FACTORY DEFAULTS
Use the following instructions to restore the User Controls and Channel Memory settings to the preset factory conditions. 1. While holding down the on the Remote Commander, press the POWER button on the Front Panel of the set. The set restarts and displays the initial setup screen. This may take several minutes.
