PIONEER KEH-P1010R/XM/EW
Instrukcja Serwisowa

IP-BUS cable

Multi-CD player (sold separately) IP-BUS input (Blue)

Note: This Product Rear output Depending on kind of vehicle, the function Power amp (sold separately) of 3* and 5* may different. In this case, be 1* (sold separately) 3* 2* Connecting cords Antenna jack Fuse

sure connect 2* 5* and 4* to 3*.

with RCA pin plugs

5* 4* other. Blue/white To system control terminal

Connect leads of the same color to each

Cap (1*) of the power amp (max. 300 mA 12 V DC). When not using this terminal, do not remove the cap. System remote control The pin position of the ISO connector will differ

(3*) Yellow (2*) depends on the type of Back-up To terminal always supplied vehicle. Connect 6* (or accessory) with power regardless of and 7* when Pin 5 is an Rear speaker In another type of vehicle, never connect (5*) Red (4*) 6* and 7*. Accessory To electric terminal controlled

ignition switch position. antenna control type.

(or back-up) by ignition switch (12 V DC) Perform these connections when using a different amp (sold separately). Blue/white (7*) To vehicle (metal) body. To Auto-antenna relay control terminal (max. 300 mA 12 V DC). Speaker leads White : Front left White/black : Front left Gray : Front right Green : Rear left Note: Green/black : Rear left In some vehicles, the ISO connector may be V iolet : Rear right divided into two. In this case, be sure to

ON/OFF. Blue/white(6*)

Black (ground)

ISO connector Gray/black : Front right

connect to both connectors. V iolet/black : Rear right

KEH-P1010R,P1013R

37