KENWOOD KRC188
Instrukcja Serwisowa

KRC-108S/188
ADJUSTMENT
Set the controls and switches as follows. BALANCE : center position BASS : center position FADER : center position TREBLE : center position LOUD : OFF DOLBY NR : OFF

No.

ITEM

TAPE

OUTPUT RECEIVER ALIGNMENT SETTINGS SETTINGS POINTS

ALIGN FOR

CASSETTE DECK SECTION
1) During FWD transport adjust (F) and (F�) so that line A of 2-LINE TAPE passes trough the center of the head shield plate (core center area) 2) During RVS transport adjust screws (R) and (R�) Head Height so that line B of 2-LINE TAPE passes trough the Screw center of the head shield plate (core center area) 3) After the alignment above, reverse the transport direction and check the FWD alignment again. If it is deviated, perform alignment again. (Tape used : SCC-1659, manufactured by A-BEX)

[1]

HEAD HEIGHT

SCC-1659

-

TAPE PLAY

[2]

HEAD TCC-153 AZIMUTH 10kHz

Connect a Head Azimuth Adjust the azimuth for each Lch/Rch or FWD/RVS AC voltmeter TAPE PLAY Screw becomes maximum to SP out.

(2-LINE TAPE)
B A (FWD) B A

(RVS)

TAPE SPEED

HEIGHT (FWD)

F

R

HEIGHT (RVS)

HEIGHT/AZIMUTH (FWD) F

R

HEIGHT/AZIMUTH (RVS)

6