|
|
|
Kto jest w sklepie?
Sklep przegląda 5999 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
KS-AX4700
Removal of main parts
CAUTION: If electricity is connected during disassembly, it must be a no load current. If it is load current, be sure to attach a heat sink to the power-amp IC. This will be damaged if the above precautions are not followed, as it does not have a sub heat sink attached to it.
B
Bottom cover
Removing the bottom cover (see Fig. 1)
1. From the bottom side of the main unit, remove the 4 screws A retaining the bottom cover. 2. Then remove the 6 screws B retaining the bottom cover. 3. Remove the bottom cover.
A
A
B
Fig. 1
Top panel
Removing the MAIN PCB (see Fig. 2 to 8)
1. Remove the bottom cover from the main unit. 2. Loosen and remove the 2 screws C retaining the top plate on the main unit. (Stoppers are attached to the backs of the C screws so that they cannot be removed easily.)
C
C
Fig. 2
3. Remove the 6 volume knobs on top of the control panel. If it cannot be pulled out easily, insert a rope or wire between the base of the volume knob and the control panel so that the volume knob is raised a little above the surface and then remove it. (Be careful when inserting a lever etc. not to scratch the surface of the control panel). 4. Remove the 4 screws D retaining the control panel. Then detach the control panel and the switch knobs.
Volume knob
D
Switch knob Control panel
D
Fig. 3
Volume knob
Rope or wire Control panel
(Side view)
Fig. 4
1-5
|
|
|
> |
|
