Preparing the remote controller
(only for KS-FX915R) This section is only for KS-FX915R. Before using the remote controller: � Aim the remote controller directly at the remote sensor on the main unit. Make sure there is no obstacle in between.
Remote sensor
2. Place the battery.
Slide the battery into the holder with the + side facing upwards so that the battery is fixed in the holder.
Lithium coin battery (product number: CR2025)
3. Return the battery holder.
Insert again the battery holder pushing it until you hear a clicking sound.
DISP TP RDS PTY
7 8 9 10 11
(back side)
� Do not expose the remote sensor to strong light (direct sunlight or artificial lighting).
WARNING:
� Store the battery in a place where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. � Do not recharge, short, disassemble or heat the battery or dispose it in a fire. Doing any of these things may cause the battery to give off heat, crack or start a fire. � Do not leave the battery with other metallic materials. Doing this may cause the battery to give off heat, crack or start a fire. � When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may start to give off heat, crack or start a fire. � Do not poke the battery with tweezers or similar tools. Doing this may cause the battery to give off heat, crack or start a fire.
Installing the battery
When the controllable range or effectiveness of the remote controller decreases, replace the battery.
1. Remove the battery holder.
1) Push out the battery holder in the direction indicated by the arrow using a ball-point pen or a similar tool. 2) Remove the battery holder.
