|
Kto jest w sklepie?
Sklep przegląda 4875 gości i 2 zarejestrowanych klientów
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
;
Schematy są ale można wysilić się i zrobić kolorowy skan i o większej rozdzielczości. Wtedy schematy płytek będą czytelniejsze. Całość super jako wartość merytoryczna. Wszystkie dane potrzebne do podłączenia różnego rodzajów urządzeń takich gramofon, CD itd.
;
Szybko, sprawnie i tanio. Serwis godny polecenia. Będę polecał innym
;
Ogólnie jest OK, z wyjątkiem obrazu płyty głównej, który jest miejscami mało czytelny, ale można sobie poradzić.
;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
KS-FX922R
Removing the head relay board (See Fig.4)
1. Unsolder the soldering b on the head relay board. 2. Remove the screw C attaching the head relay board. 3. Remove the head relay board in the direction of the arrow while releasing the two joints c. Fig.4
Cach
Head relay board
Joint c
C
Soldering b
Removing the load arm (See Fig.5)
1. Remove the E washer attaching the load arm using a pincette or something like that and remove the spring d. 2. Move the part of the load arm marked upwards to release it from the axis of rotation. Then rotate the load arm in the direction of the arrow to remove it from the cach.
Load arm E washer Spring d
Fig.5
Removing the sub chassis (See Fig.6)
Prior to performing the following procedure, remove the head relay board. 1. Remove the screw D attaching the sub chassis. 2. Push the tab e in the direction of the arrow to detach the one side of the sub chassis. Then release the sub chassis from the tab f.
Tab f Tab e Head relay board
D
Fig.6
Reinforce bracket
Removing the cassette holder and the holder arm in the eject mode (See Fig.7 and 8)
Prior to performing the following procedure, remove the head relay board, the load arm and the sub chassis. 1. Remove the screw E attaching the reinforce bracket. 2. Remove the reinforce bracket. 3. Push the tab g fixing the cassette holder in the direction of the arrow and open the cassette holder and the holder arm upward until they stop at an angle of 45 degrees. Move the two joints h to the side and remove the cassette holder and the holder arm from the shaft.
Sub chassis
Cassette mecha chassis Cassette holder
E
Reinforce bracket tab g
Head relay board
Joint h
Load arm Holder arm
Joint h
Fig.7
1-7
|
|
|
> |
|