3. Connecting the TV
Connecting an aerial to your TV
If you are not connecting your TV to a VCR, please connect the aerial lead (as shown left) and proceed to section �4.Switching on the TV�. If you are connecting your TV to a VCR please refer to the section below.
1. Connect your existing aerial lead to the socket marked
on the rear of the TV set.
Connecting an aerial and VCR to your TV
The scart lead is optional. If it can be used however, this additional connection can improve picture and sound quality when in play mode. existing aerial lead scart lead (not supplied)
OUT IN
AC IN
AERIAL ANTENNA
1. Connect your existing aerial lead to your VCR as shown. 2. Connect the VCR aerial lead from the RF OUT socket on the back of the VCR to the aerial socket on the back of the TV as shown. 3. Connect the scart lead (if used) to the AV2 socket on the rear of the TV set. 4. Connect the VCR set to the mains and switch on. 5. Insert a pre-recorded tape into the VCR and press the �PLAY� button. This enables the TV set to locate and store the video channel during the �Tuning your TV� procedure on page 5.
