...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 38 (kliknij aby zobaczyć)
FRAME SUB ASSY, BOTTOM REMOVAL
� REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
a)
� REMOVING PROCEDURES
Screw Special (Dia. 8) (+) TP 4 � 9 �2
a a
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
Slide
b b
Corner Block
39 �
b)
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
c
�2 Screw Special (Dia. 8) (+) TP 4 � 9
�2 Screw Special (Dia. 8) (+) TP 4 � 9
KV-ES38M31/ES38M61/ES38M90/ES38M91
Anode button
NOTE : When replacing the Frame Sub-Assy Top and Bottom, fix the original corner block to the new part.
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c.
�
HOW TO HANDLE AN ANODE-CAP
1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
