Nie masz w koszyku żadnych produktów
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
 |
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
 ;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
 ;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
 ;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
2-7. PICTURE TUBE REMOVAL Note:
� Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom right and left.
� REMOVAL OF ANODE-CAP
NOTE : � The picture tube is upside down, and the position for the anode cap and tension springs are changed accordingly. � Please remove necessary CRT support located on top left, top right, bottom left, bottom right, prior to removing the CRT.
!� Cushion (50x550) DGC 8 Demagnetic coil !¡ Holder DGC
� REMOVING PROCEDURES
a
!£ Cushion (35x250) DGC
a
7 Chassis assy 4 Four screws (washer head) (BVTP 3 � 12) 2 CV board 5 Deflection yoke 6 Tension spring 9 Two screws (Tapping 5 + Crown Washer)
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
A Board
b b
11 �
3 Speaker (5 � 9cm) !º Two screws (Tapping 5+ Crown Washer)
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
c
1 Anode cap
Anode Button
Coating earth assy Screw Location
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c. 1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
�
HOW TO HANDLE AN ANODE-CAP
CRT Support Block !� Picture tube !¢ Cushion
CRT Support Block
Slim Beznet
KV-PG21M10
RM-952
|
|
 |
> |
|
|
Parse Time: 0.165 - Number of Queries: 125 - Query Time: 0.036