Attach the print board. s If you are using a stand: 1. Hang the print board on the attachment fixtures of the stand. s If you are using a wallmounting kit: 1. Remove the two wing bolts and hang the print board on the wallmounting fixtures supplied with the wall-mounting kit. (Please refer to page 82.)
L
R
2
L
R
1
2. Use the two wing bolts (M5 12 mm) provided with the stand to fasten the print board to the lower stand attachment fixtures as shown below.
2. Use the two wing bolts removed in step 1 above to fasten the print board to the lower wall-mounting fixtures as shown below.
Note
CWhen mounting the print board, avoid banging it. Such impact may break the internal fluorescent light or cause other damage. CAfter mounting the print board, gradually apply weight to it to make sure that the wall is strong enough to support it.
74
CThe stand (KX-BP065) is available as an option.
CThe wall-mounting kit (KX-B063) is available as an option.