Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
Setup (Base Unit)
5
For replacement only Remove the stoppers and tags from the new ink film. Find the �T� shaped gear (blue).
Tags Stopper
New ink film �T� shaped gear (blue) Stopper Rear ink film roll Right slot
6
Insert the blue core of the front ink film roll into the right slot of the unit (#). Insert the �T� shaped gear (blue) into the left slot of the unit ($). Insert the rear ink film roll (%).
�T� shaped gear (blue)
2
3
Left slot Front ink film roll
1
Blue core
7
Turn the �T� shaped gear (blue) in the direction of the arrow. q Make sure that the ink film is wrapped around the blue core at least once. Correct Incorrect
�T� shaped gear (blue)
Tight Blue core
The ink film is not wrapped around the blue core. Ink film Slack Reverse
8
Close the back cover securely by pushing down on the dotted area at both ends (#). Close the front cover securely ($).
q
1 2
Dotted area
The following will be displayed while the unit is checking that there is no slack in the ink film. Display: PLEASE WAIT
Note:
q
Front cover Display
Back cover
The ink film is completely safe to touch, and will not rub off on your hands like carbon paper.
12
For fax advantage assistance, call 1-800-435-7329.
