PANASONIC KX-TCD955EC
Instrukcja Obsługi

Making Calls
Make sure that the power is ON (p. 12).

1 2

Press ��

. � is displayed.

Dial a phone number. � The dialled number is displayed.

� If � � flashes and an alarm tone sounds after pressing , move closer to the base unit. Then try again. � You can choose whether to display the length of the call or phone number in the talk mode by programming (p. 41).

To select the receiver volume

12345678
� After a few seconds, the display will start showing the length of the call.

3 levels (HIGH, MEDIUM, LOW) are available. The factory preset is MEDIUM. While talking, press F or G to select the desired level. � The display shows the volume level.
Ex. LOW is selected. Receiver Volume LOW HIGH

00-00-00
3
To hang up, press or place the handset on the base unit. � The handset will return to the stand-by mode.

To dial after confirming the entered number

� After a few seconds, the display will return to the length of the call.

OR
In the stand-by mode, proceed as follows.

1

Enter a phone number. � The entered number is displayed. � If you misdial, press I. Digits are erased from the right. � To cancel, press I firmly. � If your line has rotary or pulse service, any access numbers entered after pressing will not be included when dialling.

1 2 3

Press F . Press G or F until the arrow points to �Program�, then press OKH. Press G or F until the arrow points to �Receiver Volume�, then press

2

Press . �� � is displayed. � After a few seconds, the display will start showing the length of the call. To hang up, press or place the handset on the base unit. � The handset will return to the stand-by mode.

OKH.

4 5

Press F or G to select the desired level. Press OKH. � The display will return to �Receiver Volume�. To return to the stand-by mode, press C or wait for 60 seconds.

3

16