Listening to Messages Using the Handset (Remote Operation) Handset
If �New message� is displayed on the handset, new messages have been recorded. � If the Message Alert is turned on (p. 28), the Ringer/Message Alert indicator on the handset will flash slowly when new messages have been recorded and the handset is not in use.
To play back messages 1 Press [MENU]. 2 Press the soft key (Select) at �Message
play�.
� The unit announces the number of new messages and only new messages are played back from the speaker. To switch to the receiver, press [C]. To switch back to the speaker, press [s]. When you have no new messages, the unit announces �No new messages. All message playback� and plays back all messages. When you have no messages, the unit announces �No messages�. To play all messages, press [5]. If you do not press any button, the voice menu will start (see below).
Message play
KBack dB SelectL
� � � �
MENU=Call back @4 =Erase msg KRepeat SkipL
3 To end remote operation, press [OFF].
� If a call is received during playback, the unit rings and playback stops. To answer the call, press [C] or [s]. For playback, start again from the beginning after hanging up. � At the end of the last message, �End of final message� is heard. The unit will announce the remaining recording time if it is less than 3 minutes. � If you hear �Memory full� after playback, erase unnecessary messages (p. 66). � When memo messages are played (p. 67), �MEMO� is displayed.
Voice menu
If you do not press any buttons at the end of the last message, the unit will announce �End of final message� and the voice menu will begin. The unit announces, �Press 4 to play back new messages. Press 5 to play back all messages.� � You can press buttons for other playback options (p. 65) even if the voice menu has started. � If you do not press any button within 10 seconds after the voice menu, the handset will exit remote operation.
