Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
Operating Instructions
Startingyourwasher
Be sure 10 measure and add detergent starting it. then place a sorted load In the washer before
1. Select a load size l Position the Load Size Selector at the setting that describes the size of load you want to wash. 9 The selector can be set anywhere on or between EX SMALL (a few small items) and EX LARGE (a full load). l To change the water level after the washer has started to fill, slide the selector to RESET then to the desired water level. NOTE: For best washing results. Items should move freely In the washer. Do not overload the washer or choose a water level that IS too low for your wash load. For best results with permanent press clothes, use the EX LARGE water level. Reduce wash time when using EX SMALL or SMALL water level settings. Loads with only a few small items need less wash time for best results. 2. Touch a temperature selection l Match the water temperature to the type of fabnc and SOIISbeing washed l The top temperature IS the wash selectIon and the bottom temperature IS the rinse selectlon. l An Indicator shows which temperalure has been selected NOTE: Use warm wash water with the PERMANENT PRESS or KNITS GENTLE Cycles. For heavily soiled permanent press or knit clothes. pre-wash or pre-soak before washing In warm water ALWAYS use cold rinse water for permanent press fabrics
