Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 5 (kliknij aby zobaczyć)
OPERATING INSTRUCTIONS
Select Water Level
Turn the selector knob to the settingthat matches the size of the load. Thepre-setselectorknob (noton all models_can be set to four or five distinct settingsdepending on the model- EX. SMALL,SMALL,MEDIUM, LARGE,EXTRA LARGE. The infinite selectorknob (noton all models)can be moved to each water level or any point in between. If more water is needed once the fill is complete, move the knob to Reset,then to the desired setting, For best washing results,clothes mustcirculate freely. If too little water is used, poor cleaning, linting and excessivewear may result.Use the following as a guide to selectthe proper water level: Ex. Small- 1/4 full of clothes, Small (not clothes. on all models]- T/4 to 1/3 full of Medium- 1/3 to 1/2 full of clothes. Large- 1/2 to 3/4 fullof clothes. Ex. Large- 3/4 to full of clothes. NOTE: When laundering permanentpressitems or itemsof delicateconstruction, washablewoolensor looselyknit items, never uselessthan the MEDIUMsetting, Thiswill minimizeshrinkage,wrinkling and pullingof seams,
Select Wash/Rinse Water
Temperature
Turnthe selector knob to the water temperatu desired. HOT/COLD - Wash water will be the temperature of the water coming from the hc water faucet. Rinsewater will be cold. Use tl setting for heavily soiled whites and colorfas items. WARMCOLD - Wash water will be a mixh. water coming from the hot and cold water faucets. Rinsewater will be cold. Usethis foi itemswith moderate soil )evel and colored it COLD/COLD - Wash and rinse water will b temperatureof the water coming from the cc water faucet. Use this settingto minimize fac of brightly colored itemsand shrinkage of washable woolens. NOTE: Water below 6_" too cold to dissolve and activate granular Ic detergents.
Select Cycle and Time
Pushin the cycle control knob and turnclocl to the proper cycle and washtime. Washing: TheHEAVY cycleisdesigned wash very s to loads,the NORMALcycleis for average soil loadsand the UGHTcycleshouldbe select_ slightlysoiledloads.
