Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 34 (kliknij aby zobaczyć)
263740.bk : 263740 Seite 34 Dienstag, Juni 17, 1997 11:59 AM
Troubleshooting
0 Pull down the flap in the left corner of the base strip and remove it.
0 Release the emergency emptying hose from its holder. 0 Pull the emergency emptying hose out a little. 0 Place a container underneath to catch the water. 0 Release the plugs of the emergency emptying hose by turning them anticlockwise and pull them out. The water will drain out. Depending on the amount of water, it may be necessary to empty the container to catch the water several times. To do this, temporarily close the emergency emptying hose again with the plugs. When the water has drained out completely: 0 Push the plug firmly back into the emergency emptying hose. 0 Push the emergency emptying hose back in a little and let it catch onto the holder. 0 Replace the flap in the base plate and close it.
3
When the washing machine is completely empty, the �KO lock can no longer function correctly. Therefore before the next wash fill in approx 1 litre water (pour it in through the washing powder compartment).
Cleaning the drain pump
1 Warning! Switch off the washing machine and pull the plug out of the
socket before cleaning the drain pump! 0 First carry out an emergency emptying (see section "Carrying out an emergency emptying"). 0 Place a towel on the floor in front of the lid of the drain pump. Left over water may flow out.
