To change a programme already in progress, turn the selector dial to RESET position, select the new programme and then depress START button. Important! If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position COOLING and wait until the end of this phase before removing the laundry. This will avoid a build-up of heat inside the appliance.
Remove or add laundry
It is possible to interrupt the drying cycle at any time in order to remove or add laundry. Open the door. Caution! Laundry and drum can be hot. Remove or add laundry. Close the door and press START button to continue the drying cycle.
End of drying cycle
A cooling phase is performed before the end of the drying cycle: the heat is cut off during this phase. After the cooling phase, it is possible to remove the laundry from the dryer. Immediately open the door and remove the laundry.
Anti-creasing phase
If you do not remove the laundry at the end of the programme, the machine will automatically carry out an Anti-crease phase for approx 30 mins. During this period the drum will rotate at regular intervals to avoid creasing and the buzzer will sound for 1 second every 10 seconds, unless you have depressed the NO BUZZER button. The lights END and ANTI-CREASING PHASE will flash alternatively.
Switch the tumble dryer off
Depress ON/OFF button. Pull out the plug.
Clean the filters
To ensure free circulation of air during the drying cycle, the fluff filters must be cleaned after each drying cycle, before removing the laundry.
