Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
Using Your Washer
-zYeize
Whirlpool
ZSPEED ZCYCLE
Your automatic washer IS easy to To make it even easier, read the following steps before starting your first load. Start your washer after you put in detergent, the loud, and any other laundry aids according to Information on page 3.
use.
2. To adjust temperature.
the wash water )
1.
l
Select washer.
a cycle
and start the
Push the Cycle Control Knob in and turn it to the right [clockwise] l Stop when the pointer is on the number of minutes you want in the cycle you want. l Instructions for which cycles to use for each fabric type are under the lid. l To start the washer, pull the Cycle Control Knob out. When the cycle IS over, the washer WIII stop.
l To stop the washer at any time. during a cycle, push the Control Knob in. Pull it out to restart the washer l To change Q setting, push the Con-
only in the REGULAR HEAVY Cycle Push in and turn the Cycle Control Knob so the pointer is on from 10 to14 minutes in the REGULAR HEAVY Cycle Pull the Control Knob out to start.
l
Hot wash can be selected
trol Knob in to stop the washer Then turn the Control Knob to the right (clockwise] to the setting you want. Pull the knob out to start the washer
be selected in the REGULAR HEAVY Cycle Push in and turn the Cycle Control Knob so the pointer is on from 7 to 9 minutes. Pull the Control Knob out to start 4
