DESCRIPTION OF SCHEMATIC DIAGRAM
VOLTAGE MEASUREMENT CONDITION:
SCHEMATIC DIAGRAM
1. When the exclusive-use AC adapter is used, the colour bar signal of colour bar generator for service is input to get the normal screen. When the audio is minimized, the voltage value is measured with the 20 k�/V tester.
WAVEFORM MEASUREMENT CONDITION:
Models
LC-26GA5U LC-32GA5U
1. When the exclusive-use AC adapter is used, the colour density, lightness and colour hue are set to the center position, and the signal of colour bar generator for service is observed to get waveform.
INDICATION OF RESISTOR & CAPACITOR:
RESISTOR 1. The unit of resistance ��� is omitted. (K=k�=1000 �, M=M�). 2. All resistors are ± 5%, unless otherwise noted. (J= ± 5%, F= ± 1%, D= ± 0.5%) 3. All resistors are Carbon type, unless otherwise noted. C : Solid W : Cement S : Oxide Film T : Special N : Metal Coating CAPACITOR 1. All capacitors are mF, unless otherwise noted. (P=pF=mmF). 2. All capacitors are Ceramic type, unless otherwise noted. (ML) : Mylar (TA) : Tantalum (PF) : Polypro Film (ST) : Styrol
CONTENTS
Page DESCRIPTION OF SCHEMATIC DIAGRAM �������������������� D2 AV Unit ��������������������������������� D3 � D16 CPU Unit ��������������������������������D17 � D26 MAIN Unit ��������������������������������D27 � D48 LCD CONTROL Unit ���������������������������D49 � D68 KEY Unit ��������������������������������D69 � D70 POWER Unit (LC-26GA5U) ������������������������D71 � D72 POWER Unit (LC-32GA5U) ������������������������D73 � D74 INVERTER Unit (LC-26GA5U) �����������������������D75 � D76 INVERTER GROUND Unit (LC-26GA5U) ������������������D77 � D78 INVERTER-1 Unit (LC-32GA5U) ������������������������� D79 INVERTER-2 Unit (LC-32GA5U) ������������������������� D80 INVERTER GROUND Unit (LC-32GA5U) ������������������D81 � D82 R/C, LED Unit ��������������������������������� D83
CAUTION:
This circuit diagram is original one, therefore there may be a slight difference from yours.
IMPORTANT SAFETY NOTICE:
PARTS MARKED WITH �å� ( )ARE IMPORTANT FOR MAINTAINING THE SAFETY OF THE SET. BE SURE TO REPLACE THESE PARTS WITH SPECIFIED ONES FOR MAINTAINING THE SAFETY AND PERFORMANCE OF THE SET.
