SHARP LC37HV4M
Instrukcja Obsługi

HOW TO SET THE FACTORY PRESETS
Press and hold down CLEAR on the AVC System while it is in standby mode. Then press B (STANDBY/ON) button on the Display or B on the remote control unit to turn the System on. All setting items (except TV channel) return to the factory presetting.
NOTE
� Running the factory presetting operation also clears the password.

You can run the Auto Installation again by using the following steps.

1 2 3 4

Turn on the power of the Display and the AVC System. Press MENU. (Make sure the menu screen displays.) Press c/d to select �Setup�. Press ENTER.
NOTE

� If the password setting screen displays, you need to enter your password. � If you forget your password, refer to HOW TO SET THE FACTORY PRESETS above.

5 6

Press a/b to select �Auto Installation�. Press ENTER.

The password is
NOTE

.

� As a precautionary measure, make a note of your password above, scissor it from this manual, and keep it in a familiar place.

73