Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
Installation
The appliance must be securely fixed to a wall for stability to avoid any risk of the appliance falling forward. The mains plug must be accessible after installation. Ensure adequate space is maintained for the routing of the supply cord. For appliance dimensions see page 5 � Technical data. The spinner location pin is sharp care must be taken when placing the spinner into position and when installing the unit or replacing the lamp.
Lamp; Spinner and Glass Bed Location
Ensure mains lead is switched off and/or disconnected. Remove the four panel screws; place the lamp firmly into the lamp holder ensuring that the pins on the lamp align with the location tabs on the lamp holder; rotate clockwise until positively located. Remove the protective pin cap situated above the lamp holder; place the spinner onto the location pin ensuring that the spinner turns freely, slide glass bed into position with the frosted side down and re-fit front cover. Place the decorative pebbles randomly on the glass bed; alter the stone positions until the desired effect is achieved.
Trim location
Place each of the magnets onto the location brackets. If applicable remove the protective film from the trim. Fit the trim ensuring positive location against magnets. The trim may appear to be warped this is caused by the spot welding process and is normal; when fitted to the magnets the warp should not be visible.
Important!!!
The appliance is supplied with decorative pebbles some are small; care should be taken to prevent young children removing the small stones as they are considered a choking hazard. Power Switch Press ( ) for Power On. Press (o) for power off Heater Switch Press ( ) for 1000W. Press ( ) for 2000W. Central position; heater off (effect only) Front Always switch power off when not required to operate. Of unit Switch location
