Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
Washer Operating Instructions
The drawings in this book may vary slightly from your washer model. They are designed to show the different features of all the models covered by this book. NOTE: Your model may not include all the features shown.
Starting your washer
Be sure to measure and add detergent, then place a sorted load in the washer before starting it. 1. Select a load size l Turn the knob to point at a setting that describes the size of load you want to wash. l Set the knob on or between EX SMALL (a few items) and LARGE (a full load). NOTE: Use the LARGE water level for best permanent press results.
2. Select water temperature l Match the water temperature to the type of fabric and soils being washed. l The top temperature is the wash selection and the bottom temperature is the rinse selection. NOTE: Use warm wash water with the PERMANENT PRESS or KNITS/ GENTLE Cycles. For heavily soiled permanent press or knit clothes, pre-wash or presoak before washing in warm water. ALWAYS use cold rinse water for permanent press fabrics. 3. Select cycle and wash time Start the washer l Push in the Cycle Control Knob an turn it to the right. l Stop on the number in the waste Cycle you want. The numbers are niinutes Of wash time. l Start the washer by pulling out the Cycle Control Knob. The washer Will fill to the selected water level with the selected wash w dter temperature. After filling, the washer will agitate for the selected nrumber of minutes. l To stop the washer at any time, push in the Cycle Control Knob. To restart the washer, PI III out the Cycle Control Knob.
