PHILIPS LTC2821/90
Instrukcja Obsługi

2.2

Rear Panel

Pin No. 1 2 3 4

Signal GND (Y) GND (C) Y C

Rear panel
9

Video A terminals [VIDEO A IN/OUT] Video signal input (IN) and output (OUT) terminals The output terminal is bridge-connected (auto termination). IN : Video signal input terminal OUT : Bridge-connected video signal output terminal

12

Audio A, B, C terminals [AUDIO A, B, C IN/OUT] Audio signal input (IN) and output (OUT) terminals. The output terminal is bridge-connected. IN : Audio signal input terminal OUT : Bridge-connected audio signal output terminal

NOTE: For corresponding audio signals, use the AUDIO A terminals 12 .
10

NOTE: For corresponding video signals, use the VIDEO terminals 9 , 10 , 11 .
13

Video B terminals [VIDEO B IN/OUT] Video signal input (IN) and output (OUT) terminals. The output terminal is bridge-connected (auto termination). IN : Video signal input terminal OUT : Bridge-connected video signal output terminal

AC Inlet Power input connector. Connects the supplied AC power cord to the appropriate AC outlet.

NOTE: For corresponding audio signals, use the AUDIO B terminals 12 .
11

Video C (Y/C) terminals [VIDEO C Y/C IN/OUT] Y/C (S-Video) signal input (IN) and output (OUT) terminals. The output terminal is bridge-connected (auto termination). IN : Y/C-separated (S-video) signal input terminal OUT : Bridge-connected Y/C-separated (S-video) signal output terminal

Note: The impedance is automatically set to 75 � by the input of a signal on the input connector while operating in a single connection mode. However, if a cable is connected to the output connector, the connection is placed into the open status by the multiple connection and high impedance automatically selected. Do not leave an unused cable connected to the monitor. If a single cable is used, then it must be connected to the input connector for the 75 � auto termination selector to function properly.

NOTE: For corresponding audio signals, use the AUDIO C terminals 12 .

1.4