JVC LT-Z37DX5
Instrukcja Obsługi

Failure to take the following precautions may cause damage to the television or remote control.
DO NOT block the TV�s ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) DO NOT place anything on top of the TV. (such as cosmetics or medicines, flower vases, potted plants, cups, etc.) DO NOT allow objects or liquid into the cabinet openings. (If water or liquid is allowed to enter this equipment, fire or electric shock may be caused.) DO NOT place any naked flame sources, such as lighted candles, on the TV. DO NOT subject the TV to direct sunlight. The surface of the TV screen is easily damaged. Be very careful with it when handling the TV. Should the TV screen become soiled, wipe it with a soft dry cloth. Never rub it forcefully. Never use any cleaner or detergent on it. If there is a fault, unplug the unit and call a service technician. Do not attempt to repair it yourself or remove the rear cover.

ENGLISH

Cleaning the screen
The screen is coated with a special thin film to reduce reflection. If this film is damaged, uneven colours, discolouration, scratches, and other problems that cannot be repaired may occur. Pay attention to the following when handling the screen. � Do not use glue or adhesive tape on the screen. � Do not write on the screen. � Do not allow the screen to come in contact with any hard objects. � Do not allow condensation to form on the screen. � Do not use alcohol, thinner, benzene or other solvents on the screen. � Do not rub the screen hard.

CAUTION:
� Operate only from the power source specified (AC 110 � 240 V, 50/60 Hz) on the unit. � Avoid damaging the AC plug and power cord. � When you are not using this unit for a long period of time, it is recommended that you disconnect the power cord from the main outlet.

Demonstration
To start the demonstration: Press the H button to display the menu bar. Then press the yellow button. Select DEMO 1 (High Speed Response) or DEMO 2 (DynaPix) from the DEMO MODE menu. Press the 6 buttons, then press the a button. To quit the demonstration: Press the yellow button, b button, 6 p buttons or any of the number buttons.

2