jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
PRECAUTIONS
To prevent damage of the thermal head caused by static electricity when assembling the chassis ass'y into the unit, the following steps must be followed; 1 : Turn the power switch off. 2 : Discharge the capacitor C18(2200µF) on the PCB L271-1. CN301 3 : Connect the FPC of chassis ass'y into a connector CN301 of PCB L271-2. 4 : Assemble the chassis ass'y. 5 : Turn the power switch on.
PCB L271-2
FPC
C18
LSI1
Chassis ass'y
ADJUSTMENT
Adjustment of low battery detection circuit
PCB L271-1
Figure-4
To adjust the threshold voltage of the low battery detection circuit, the following steps must be followed; 1 : Apply 6.2V + 0.1V / -0V to the battery terminals. 2 : Ground check pads CP45 and CP46. 3 : Adjust a pot VR1 so that the voltage between CP1 and CP2 is 0V ± 10 mV.
Multi-meter PCB-L271-1
+
CP2 CP1
VR1 CP46
BATT
-
CP45
+
6.2V (+0.1 / -0 V) Power supply
BATT +
GND
Figure-5 Setting the thermal head rank Set the thermal head rank with pads RNK1 and RNK2 on the PCB L271-1 according to the following conditions when replacing the chassis ass'y or thermal head. The head rank is indicated on FPC as following figure-6. Head rank A : RNK1=ON, Head rank B : RNK1=OFF, Head rank C : RNK1=ON, Head rank D : RNK1=OFF, RNK2=OFF RNK2=OFF RNK2=ON RNK2=ON
