jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
DECODER ALIGNMENT
TEST LIMITS Adjust for minimum voltage
ADJUST
REMARKS
67KC Trap (L-6)
Stereo light must be on. This is done by adjusting the "MPX Light Adj." control, R-12.
T-6 top and bottom; L-5
Adjust for maximum voltage
Stereo light must be off.
�~
T-7 bottom core
SAME
Stereo light must be completely on.
T-7 top core
Adjust for stable scope display
1. Turn off 19KC pilot on MPX generator. 2. Adjust upper core of T-7 to obtain a stable and uniform 1 KC signal scope display. This adjustment may be critical, so turn core very slowly. 3. Turn 19KC pilot back on. Modulate left channel and measure right channel output. Adjust L-5 for minimum right channel output (maximum separation). Be sure all test leads are removed from TP#2 for separation tests. Modulate right channel and measure left channel output. Separation in steps 5 and 6 should be at least 30db.
L-5
30db separation or more SAME
This step checks the rejection of 19KC and 38KC frequencies. Residual output should be at least 40db below modulated output. MPX light adjust control R-12 Turn control until light comes on. Then back off just enough to cause the light to go off. Then back off about 1/8 of a turn more. Light should operate ONLY on a MPX signal.
