PHILIPS MCD139B/05
Instrukcja Obsługi

Clock/Timer
Viewing clock
The clock (if it is set) will be shown in standby mode. To view the clock in any source mode (DISC or TUNER for example), or Ecopower standby mode � Press briefly CLOCK on the remote. � The clock is displayed for a few seconds. � If the clock has not been set, "--:--" is displayed for a few seconds. � The source and timer digits will be lighted on the display panel. � � NO TIMER � will be displayed briefly if wake-up timer is not set.

2

Press DISC or TUNER to select the desired source.

� Before setting timer, make sure the music source has been prepared. DISC � load the disc. TUNER � tune to the desired radio station.

1

Setting clock

In standby or any source mode, press and hold CLOCK on the remote. � The clock digits flash on the display panel. � If the clock has not been set, "--:--" flashes

3 4 5

Press ¡ / � repeatedly to set the hour.

Press à / á repeatedly to set the minute. Press SLEEP/TIMER to store the time.

� At the preset time, the selected source will play. To deactivate the wake-up timer � In standby mode, press and hold SLEEP/ TIMER until �TIMER OFF� is displayed on the panel. Notes: � The system will exit timer setting mode if no button is pressed within 25 seconds. � Display shows if activated, and disappears if deactivated.

2 3 4 5

Press ¡ / � on the set repeatedly to set the hour. Press à / á on the set repeatedly to set the minute. Press and hold MODE on the front panel for more than 5 seconds to toggle between 12-hour and 24-hour display. Press CLOCK agian to store the setting. � The clock starts working.

Setting sleep timer
Notes: � The clock setting will be erased when the system is disconnected from the power supply. � The system will exit clock setting mode if no button is pressed within 25 seconds. � To exit clock setting without storing, press STOP on the system to exit. The sleep timer enables the system to switch off by itself after a set period of time.

1

Press SLEEP/TIMER on the remote control repeatedly to select a preset time. � The selections are as follows (time in minutes): 15 � 30 � 45 � 60 � 90 �120 � OFF Press SLEEP/TIMER until you reach the desired length of time. To deactivate the sleep timer

Setting wake-up timer
The system can switch on to DISC or TUNER mode automatically at a preset time, serving as an alarm to wake you up. IMPORTANT! � Before setting the timer, ensure that the clock is set correctly. � To set a new timer, you need to deactivate the previously set timer.

2

� Press SLEEP/TIMER repeatedly until "OFF" is displayed, or press the STANDBY ON y button.

1

In standby mode, press and hold SLEEP/ TIMER on the remote for more than five seconds to enter timer setting mode. 31

English