Troubleshooting
English
40 Problem The DVD player does not start playback. Solution
� Insert a readable disc. � Check the disc type, color system and region
code.
� Clean the disc. � Place the disc with the playback side down. � Press SYSTEM MENU to turn off the setup
menu.
� Cancel the parental control rating function or
change the rating level.
� Moisture has condensed inside the system.
Remove the disc and leave the system turned on for about an hour. The DVD player does not respond when buttons are pressed. The language for the sound or subtitle cannot be changed when playing a DVD.
� Disconnect the power plug from the jack, and
insert again.
� Multi-language sound or subtitle is not recorded
on the DVD.
� Changing the language for the sound or subtitle
is prohibited on the DVD. No image is output when a function is selected.
� Make sure the component is connected
correctly.
� Press the correct function button for the input
source. Sound cannot be heard or is of poor quality
� Adjust the volume. � Disconnect the headphones. � Check that the speakers are connected correctly. � Check if the stripped speaker wire is clamped. � If the system is in pause, slow motion or fast
forward/reverse mode, press PLAY/PAUSE 2; to resume the normal play mode. � Make sure the MP3-CD was recorded within 32256 kbps bit rate with sampling frequencies at 48 kHz, 44.1 kHz or 32 kHz. � Ensure that the DTS disc also supports Dolby Digital output. Poor radio reception.
� If the signal is too weak, adjust the antenna or
connect an external antenna for better reception. � Increase the distance between the System and your TV set or VCR.
