Tape Operation / Recording
General information on recording
ECO POWER BAND CLOCK SET STANDBY-ON RECORD DISPLAY RDS
MCM720 MICRO SYSTEM
� For recording, use only NORMAL (IEC type I) tapes on which the tabs have not yet been broken. This deck is not suited for recording on METAL (IEC IV) type tapes.
iR
USB DIRECT
ALBUM / PRESET
TUNING
VOLUME
TIMER SET SOURCE PROGRAM DSC DBB INCREDIBLE SURROUND
� The best recording level is set automatically. Altering the VOLUME, INCREDIBLE SURROUND or DBB will not affect the recording in progress. � At the very beginning and end of the tape, no recording will take place during the 7 seconds when the leader tape passes the recorder heads.
Tape playback 1 2 3
Select TAPE source. � The display shows �TAPE briefly, and the TAPE TAPE� tape counter 000 is displayed. Press OPEN/CLOSE ç to open the tape door. Insert a recorded tape and close the tape door.
� To protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this side is no longer possible. If, however, you wish to record over this side again, cover the tabs with a piece of adhesive tape. IMPORTANT! Recording is permissible if copyright or other rights of third parties are not infringed upon.
� Load the tape with the open side downward and the full spool to the left.
4
Press � to start playback. �
Preparation for recording
To stop playback � Press �. To reset the tape counter display � In stop mode, press � once.
1 2 3
Select TAPE source. Load a recordable tape into tape deck with full spool to the left. Prepare the source to be recorded. CD � load the disc. TUNER � tune to the desired radio station. AUX � connect external equipment. When recording is in progress � REC flashes.
Rewinding / Fast forwarding 1
Press TUNING S/T (à /á on the remote control). � The tape will stop automatically at the end of rewinding or fast forwarding. � During fast winding, you can monitor the tape message with the tape counter.
� To stop recording, press 9. � It is not possible to listen to another source. � It is not possible to activate the timer function.
