|
|
|
Kto jest w sklepie?
Sklep przegląda 5841 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
...instruction is ok.
...instrukcja jest ok.
Thanks/Dzięki
;
Documentation made available quickly and It is good quality. Thanks.
MC-UG585-00
and the plastic shaft, pry out the plastic shaft as illustrated.
3.5.2.
Installation
1. Install the window, furniture guard, and nozzle packing, if not already in place in the new nozzle housing. Remove plastic shaft, handle release assy, light bulb assy, and reflector. 2. Fit the nozzle onto the main body by sliding the nozzle housing between the frame and the main body on the motor shaft side and the headlight wire through the slot on the opposite side as illustrated. 6. Remove the nozzle housing by pulling off of main body as illustrated. Both sides are slotted, one to clear headlight wire and the other to clear the motor shaft.
3. Slide the plastic shaft through the nozzle housing and into the dust container. Make sure that the slot on the bottom of the plastic shaft is down and fitted onto the projection.
7. Remove the nozzle packing and furniture guard from the nozzle housing.
4. Replace the three (3) screws that secures the pedal assembly. 5. Replace the reflector, headlight assembly, and nozzle hose. The nozzle hose has a locator tab that fits into a slot in the main body. 6. Install the belt, agitator assembly, and the lower plate according to their respective instructions.
8. Remove the window by prying the two (2) locking tabs away from the nozzle housing and pushing out on the window. Remove plastic shaft, handle release assy, light bulb assy, and reflector. CAUTION: If the motor case cover is removed, DO NOT turn vacuum over as the motor may fall out.
12
|
|
|
> |
|
