PANASONIC MC-UG787-00
Instrukcja Serwisowa

MC-UG787-00

4 SERVICE PROCEDURES - NOZZLE
4.1.
4.1.1.

Nozzle cover
Removal

1. Release the nozzle cover by rotating the nozzle cover retainers to the UNLOCK position. 2. Rotate upward on the nozzle cover to remove it from the nozzle base.

2. Disconnect power cord from electrical outlet. Press handle release pedal and tilt the handle down so cleaner is lying flat on the floor. 3. Position hands on agitator. If the belt is still attached to the agitator, there will be tension on it. 4. Carefully lift the right end of the agitator and then lift the left end.

4.1.2.

Installation

1. To replace the nozzle cover, make sure the nozzle cover retainers are in the UNLOCK position. 2. Hook the front of the nozzle cover onto the nozzle base and rotate downward. 3. Once inplace, rotate the nozzle cover retainers to the LOCK position.

5. Remove the belt from the motor drive shaft.

4.2.2.

Installation

1. Reinstall new belt if necessary. 2. To replace the agitator, place the belt around the motor shaft.

4.2.
4.2.1.

Agitator / Belt Replacment
Removal
nozzle cover (see NOZZLE COVER

1. Remove the REMOVAL).

15