|
|
|
Kto jest w sklepie?
Sklep przegląda 5891 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
 ;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
;
Instrukcja Serwisowa jest kompletna i czytelna. Dziękuję!
;
Wszystko OK!
Dokumentacja jest czytelna.
Dziękuję.
;
Bardzo dobra jakość skanu, przystępna cena. Instrukcja serwisowa okazała się przydatna przy "reanimowaniu" dwudziestoparoletniego decka, który teraz pięknie gra :)
WIRING MANAGEMENT DRAWING
NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical component or electrical enclosure, the unit should be reassembled and checked for dielectric breakdown or current leakage.
POWER CORD REPLACEMENT
Removal
1. Refer to Handle Removal / Installation Section, page 16. 2. With handle removed from body disassemble handle by removing fourteen (14) screws. Refer to Handle Exploded View (page 10). 3. Remove handle release button and spring.
BLACK (SWITCH) BLACK (SWITCH) CABLE TIE
4. Remove damaged cord.
Installation
1. Replace damaged cord. carefully routing power cord as illustrated in (Fig. 11). 2. Reinstall handle as outlined in the handle installation section. 3. Replace the cord stopper, the two (2) cord stopper screws and the wire connectors. NOTE: Never reuse a cord stopper. Always install a new cord stopper whenever the old one is removed.
Power Cord
(Fig. 11)
Note: Powercord should extend 75mm beyond the cord stopper and routed towards sidewall as shown. The three (3) groups of wire should be tied along with the switch wires with a cable tie.
Handle
BLACK (POWER) WHITE (POWER) CORD STOPPER BLACK (JUMPER) WHITE (JUMPER)
NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical component or electrical enclosure, the unit should be reassembled and checked for dielectric breakdown or current leakage.
ON / OFF SWITCH REPLACEMENT
Removal
1. Remove the dust cover to expose the electrical connections of the ON/OFF switch. 2. Remove the insulated black wire lead from switch. Note the location of the insulated lead when removing from switch. 3. Remove uninsulated black wire from switch.
WHITE (LIGHT)
Retaining Tabs Black (Insulated) Black
(Fig. 12)
YELLOW (LIGHT)
4. Remove the ON/OFF switch, (for ON/OFF switch replacement) by depressing the switch retaining tabs while pushing up out of the dust compartment at the same time.
WHITE (MOTOR)
Installation
1. When re-connecting lead wires to ON/OFF switch make sure the insulated lead is reconnected to its original location as shown in Fig.12.
GRAY (MOTOR/FUSE)
-4-
- 17 -
|
|
|
> |
|
