Bardzo dobra jakość skanu, przystępna cena. Instrukcja serwisowa okazała się przydatna przy "reanimowaniu" dwudziestoparoletniego decka, który teraz pięknie gra :)
Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 14 (kliknij aby zobaczyć)
MC-V9641-00
4 SERVICE PROCEDURES - CANISTER
4.1.
4.1.1.
HOOD
Removal
1. Lift up on the hood release as the hood is raised. 2. With the hood all the way up, force it until the two ends pop out of place.
3. Lift the canopy cover off of the canister base. 4. Secure the power cord to prevent retracting as you are servicing the motor.
4.1.2.
Replacement
4.2.2.
Replacement
1. Place each end of the hood into the slot while holding upright in the position it was removed. 2. Work both ends into the openings and close.
1. Set the canopy cover in position and secure the canopy with (4) screw holes. 2. Replace the foam over the cord rewind button. 3. Snap the brake pedal in to place on the canopy cover.
4.2.
4.2.1.
front.
CANOPY COVER
Removal
4.3.
4.3.1.
CORD REEL
Removal
1. Remove the brake pedal by snapping it off from rear to
1. Remove hood (see HOOD Removal). 2. Remove canopy cover (see CANOPY COVER Removal). 3. Disconnect both cord reel wires. 4. Remove the cord cover cap from the base. 5. Lift the cord reel straight up to remove. Do this by prying it out of the retainers.
2. The canopy cover has a screw on each of the four (4) corners sercuring it in place. Use a screwdriver to remove each screw.
